www.fsm.ag
+49 7661 9855 0
[email protected]
FSM AG
Erich-Rieder-Straße 2
D-79199 Kirchzarten
1|4
>
User Manual
Clean Room Sensor | Type
PMDS4
Connections/ Installation Position
Process connection
Discharge connection Ø 6.6 x 11mm for flexible hoses Ø 6mm on the rear wall of the housing (next to the electrical termi
-
nals).
Calibration connection
Connection on front panel through discharge connection Ø 3 x 4mm for flexible hoses Ø 3 after having removed the caps.
Installation position
The device is installed in a vertical position. Attention: Do not clamp discharge hoses as this may result in failures.
Assignment Of Buttons
S button:
Using this button will bring you from the display level directly to the command value level. After having set the
required command values you can exit the menu by using the S button again. In addition, the button can be used to navi
-
gate within the display (skipping within the display).
M button:
Using the M button will bring you from the display level to the menu level. By pressing this button several times
you can exit the menu and the sub-menu items.
Arrow buttons:
Using these two buttons, you can move backwards and forwards within a menu item. In addition, the arrow
buttons can also be used to set the individual values in the menu items.
PMDS4 is a pressure gauge suitable for over-pressure and under-pressure monitoring of non-ag
-
gressive gases that is equipped with additional interfaces for further sensors (e.g. for temperature
or flow measurement), as well as with an internal pressure sensor. The device can be installed direct
-
ly into the walls of clean rooms.
Wiring Diagram
28.
01.2
016
