FSLaser 36x24, Руководство по установке и настройке

Страница: 35 / 42

[28]
12. Once the mirror #1 is aligned, we will adjust mirror #2. Put a piece of thermal paper
on mirror #3. Using the red dot, adjust the mirror until the red laser is somewhere on
the mirror.
13. Move the laserhead to the far right position. Fire a test dot here producing a black
dot. The red and black dot may be off slightly because the distance travelled by the
laser beams is longer so any small errors are amplified. Without touching any of the
mirrors, adjust the red dot to overlap with the black dot through the screws on the red
laser diode mount or twisting the red laser diode mount.
14. Put on a new piece of thermal paper. Move the laser head to the far left and fire a
black dot. Move the laser head to the far right and fire a second black dot.
15. Now you should have two black dots on the thermal paper and the red dot. Verify as
you move from the left side to the right side that the red pointer tracks between the
two black dots.
16. Move the laser head to the far right. The red laser dot should overlap with one of the
black dots. Adjusting only mirror #2, move the red dot between the two black dots.
17. Replace with a new piece of thermal paper and fire dots in the far left and far right
positions. Again move to the far right position then adjust the red dot between the
two black dots. Repeat until the two black dots are exactly on top of each other.
Mirror #2 is now aligned.
18. Once mirror #2 is aligned, put a piece of thermal paper on top of the lens. Adjust the
screws on mirror #3 until the red dot is in the center of the lens. Fire a black dot into
the thermal paper.
Black dots are
closer
-Move red dot between
two black dots
-Repeat until both on top
Laser fire dot
from far left
Laser fire
dot from
far right
Adjust mirror until
red dot between