FSL3D Phoenix Touch, Руководство пользователя

Страница: 29 / 45

29
Finishing
● Use the flush cutters to snip away supports.
● Put the model on some paper towels to dry.
● You can finish here, but post curing is recommended for surface finish and print
hardness
Post­curing
● Printed objects are by design cured to about 90% strength to extend the useful life of the
SuperVAT™.
● To fully cure your prints, expose your prints to a UV light for 30 minutes. Speed Cast
resin requires a minimum of an hour of curing. This ensures that the model is
completely dry for proper casting burnouts.
● Alternatively, you may place the models in sunlight to cure. Sunlight may cause the
clear models to turn slightly yellow as sunlight contains a certain wavelength of light that
breaks down color additives in the resin.
Post Processing
● After curing, use sandpaper to remove any imperfections. Rinse in IPA to remove dust.
You ​ will not ​ need to post cure again.
● You can use any finishing processes at this point. eg. Painting
[Main Menu]