4-PORTS 10/100/1000M GIGABIT PoE+ EXTENDER USER MANUAL
7
5.
2
Connecting POEX4 to PSE
This section describes how to install Gigabit PoE Extender and make connection to it. Please read the following descriptions and
perform the procedures in the order being presented.
There are 4 RJ45 ports in the Gigabit PoE Extender, of which the
“PoE IN”
port functions as
"PoE (Data and Power) input"
and the
four
”PoE Out”
ports function as
"PoE (Data and Power) output"
.
Step 1:
Connect a standard Cat5e/6 UTP cable from
PSE
, such as PoE++ switch, PoE++ injector hub and single port PoE++ injector,
to the
“PoE IN”
port of the Gigabit PoE Extender.
Step 2:
The PSE delivers both Ethernet data and PoE power over UTP cable to the Gigabit PoE Extender.
Note:
1. When the PoE-in-Use LED turns steady orange, it means the Gigabit PoE OUT is supplying power successfully from PSE.
2. If the PoE-in-use LED is not lit, please check the remote PSE or the cable connecting to a PC or a network device to see if the cable
is correct.
Cautions:
Never connect any
non-standard
PoE PSE to the Gigabit PoE Extender or else it will damage the device permanently.
