Assemble FOSC Housing
1. Check up comprehensively.
2. Put the FOSC cover on the FOSC bottom directly.
3. Put two pieces of insert plates into the slot.
4. Insert two pieces of locating bolt of FOSC and tighten it with the special wrench.
5. If the FOSC is for aerial application, then put the hanging hook on one side of the closure and then
tighten fixing bolts on both sides. Otherwise tighten the four fixing bolts on 5.9.5 four corners
respectively.
Online Resources
Download
Help Center
Contact Us
https://www.fs.com/products_support.html
https://www.fs.com/service/fs_support.html
https://www.fs.com/contact_us.html
NOTE:
Clean the housing and pay attention to the above sequence.
EN
8
Seal fitting
Fixing device
for reinforced core
Fixing slot of heat shrinkable
protective sleeve
Optical cable pressure block
Seal tap
Optical cable
pressure block
Fiber
Lock of FOST
FOST
Port plug B
Terminal A fiber cable
Heat shrinlable protective sleeve
Cover of FOST
