Step 4: After setting the parameters, click
Connect
to enter. And then enter the default password,
admin.
Troubleshooting
The screen displays request timed out
1. Check if the network cable is intact.
2. Check if the hardware connection is correct.
3. The system status indicator on the device panel and the NIC indicator on the computer must be lit.
4. The computer’s IP address setting is correct.
LED does not light up after the AP is powered on
1.If you use PoE power supply, verify that the power source is IEEE 802.11af compliant; then verify that
the cable is properly connected.
2.If you use a power adapter, verify that the power adapter is connected to an active power outlet;
then verify that the power adapter works properly.
Serial
Flow Control
DTR/DSR
RTS/CTS
XON/XOFF
Save session
Open in a tab
Cancel
COM3
9600
8
None
1
Show quick connect on startup
Configuring the AP Using the Console Port (FAT AP Mode)
Step 1: Connect a computer to the AP's console port using the console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 9600 bits per second, 8 data bits, no parity, 1 stop bit
and no flow control.
Quick Connect
x
Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Connect
