frozy FR25 SI, Руководство пользователя

Страница: 11 / 20

Installation

Remove and disassemble all packaging materials of the product before
installation.

The ice wire, waterproofing plastics and the ice scoop are provided inside the
product. If any part or accessory is missing, please contact our customer services.

Clean the inner body with warm water and a soft cloth before using the ice maker.
Clean the ice trays with warm soapy water. Dry with a soft, cotton cloth. After
placing the ice maker at the installation point, wait 2 (two) hours before operating
to get the cooling system pressure stabilized. Install the parts inside the ice maker
in accordance with the assembly instructions.

The cold water inlet must not exceed the operating water pressure (5 Bar)
indicated on the technical data sheet. If the line pressure is higher than 5 Bar, a
pressure reducer must be installed.

Connect your device to the mono phase - grounded power supply of the rating
indicated on the nameplate. Your device is designed to function normally within
± 10% of the main voltage. If this range cannot be provided in your local power
network, it is recommended to use a voltage regulator.

If it is necessary to change the location of your ice maker, be sure to transport the
unit according to the markings on the original packaging of the device.

Protect your device against factors that may damage the package and the device
(moisture, water, impact, chemical, etc.).

Only Authorized Service should disassemble the device. Never interfere with the
internal parts and elements of the ice-maker.

The device must be commissioned by the Authorized Service.

Failure to comply with the above conditions will void your product warranty.

Do not leave packaging materials (plastic bags, nylon, etc.) within the reach of
children.

The manufacturer reserves the right to change the information in this manual.
Therefore; this booklet does not constitute a commitment to specifications.