Frontgate Holiday 68607, Руководство пользователя

Страница: 10 / 21

2.2 –
Locate Tree Section “A” and insert Tree Section “A” into the tree stand. Make sure the pole is firmly inserted
into the stand, and then turn all three screws until contact is made with the pole. If Section “A” is not sitting straight,
then simply loosen the screws, adjust tree pole, and retighten the screws.
All the branches are connected to the tree’s center pole by metal hinges (See Figure 2). Remove the packing strap that is
around the tree section and allow the branches to fall into place.
2.3 – Locate Tree Section “B” and insert into the top of Tree Section “A”. Make sure section “B” is seated securely into
the top of section “A”. Remove the packing strap that is wrapped around this tree section, same as you for Section “A”.
Allow the branches and leaves to fall into place.
2.4 – Locate Tree Section “C” and insert into the top of the Tree Section “B”. Make sure section “C” is seated securely
into the top of section “B”. Remove the packing strap that is wrapped around this tree section, same as you for Section
“B”. Allow the branches and leaves to fall into place.
2.5 –
Locate Tree Section “D” and insert into the top of the Tree Section “C”. Make sure section “D” is seated securely
into the top of section “C”. Remove the packing strap that is wrapped around this tree section, same as you for Section
“C”. Allow the branches and leaves to fall into place.
3. Light Set and Power Connection:
3.1 – Your tree is lighted with Commercial grade miniature lights that are strung on the tree at the factory. Because your tree
is adorned with 1700 lights, to avoid overload of fuses within the tree, each section with the exception of the Tree Top
section is strung into a separate TREE SECTION EXTENSION CORD that is 8' in length. This 8' is to allow you to drop
this cord down to the bottom of the tree so it can plug into a power strip or multi tap extension cord. For your
convenience, each of these TREE SECTION EXTENSION CORDS has a built in foot pedal on/off switch so you can
turn each section on and off with a tap of your foot.
Please note : Tied to the plug of each of these extension cords is a
red tag (see attached photo) which says "Please Plug Into Electrical Wall Outlet Only". This means that you should plug
each TREE SECTION 8' EXTENSION CORD either into a wall outlet, or into a power strip. This tag is trying to prevent
someone from plugging one TREE SECTION EXTENSION CORD into another TREE SECTION EXTENSION
CORD (this will blow a fuse in the extension cord).
3.2 – Your tree will include 3 foot pedals that will then plug into the wall or power strip. This will allow ease of turning your
lights on and off.