Frontgate 142157, Руководство по сборке

Страница: 19 / 27

F R O N T G A T E
®
Holiday Collection
JACKSON SPRUCE 10ft TREE
(142160A CLE & 142160B CLE)
and/or
(142160A MUL & 142160B MUL)
ASSEMBLY INSTRUCTIONS
(4 SECTIONS WITH 3 EXTENSION CORDS)
PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE
Your 10’ Jackson Spruce Tree should contain the following:
1 Tree stand Accessory kit
If any piece is missing please contact a Frontgate 3 Eyelet screws 4 Tree sections labeled A, B, C, D
Product Specialist 1 Power strip 1 Remote control with receiver
1 Power Strip/Surge Protector
HOW TO ASSEMBLE AND SHAPE YOUR TREE:
1. BEFORE STARTING TO ASSEMBLE YOUR TREE, CHOOSE A LOCATION NEAR AN 110V ELECTRICAL WALL
OUTLET FOR THE PRELIT TREE.
2. REMOVE THE 4 TREE SECTIONS FROM THE TWO CARTONS.
3. THE SECTIONS OF THE TREE ARE MARKED A THROUGH D. “SECTION A” IS THE BOTTOM, “SECTION B”
IS THE LOWER MIDDLE AND “SECTION C” IS THE UPPER MIDDLE AND “SECTION D” IS THE TOP.
4. PLACE THE TREE STAND ON A LEVEL SURFACE AND INSTALL THE BOTTOM END OF THE LOWER
“SECTION A” INTO THE STAND. HOLD THE SECTION IN A LEVEL POSITION AND TIGHTEN THE THREE
SCREWS IN THE STAND AGAINST THE TREE TRUNK SURFACE. MAKE SURE THE SCREWS ARE
TIGHTENED AS EVENLY AS POSSIBLE MAINTAINING A SNUG AND SECURE POSITION. (FIG 1~2)
FIGURE 1 FIGURE 2