3
•
Turn on the Noise Cancelling feature by tuning the On/Off switch on Left side to
on.
5. OPERATION
To begin listening to your music -
•
Turn on the audio source, plug in the 3.5mm plug of the dongle into
audio source
•
Turn on the dongle by pressing the power button for 3 seconds. The
blue LED will light up.
•
Turn on the headphone receiver by pressing power button for 3
seconds, the LED will turn Green.
•
When the audio link is established between dongle and headphone, the
blue LED on dongle flashes and headphone become solid.
•
Turn on Noise Cancelling feature on headphone by moving the On/Off
switch on the left side to On.
•
When you are done listening, turn OFF the dongle and headphones by
pressing Power button for 3 seconds. Turn off Noise Cancelling feature
on headphone by moving the On/Off switch on the left side to Off.
Pairing:
If the headphones do not work after following the processes above, start the pairing
process over by pressing the Power button for 12 seconds in the dongle in shutdown
state. After that, press the headphone pair button until the blue LEDs flash. The LEDs
will change to solid blue when pairing process is finished.
NOTE:
In order to protect the dongle and save power, the dongle will automatically switch to
stand-by mode (LED will turn off) after approximately 2 minutes if there is no audio
signal, or if the signal that it receives from the audio source is too weak for proper
reception. If the signal returns to an acceptable level, then the transmitter will
automatically switch back to on. The dongle will automatically shut off if stand-by
mode last for more than 15 minutes.
The headphone receiver will automatically shut off if it gets no signal from transmitter
for 15 minutes.
