background image

WTAN030_REV_A01

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

1

front runner

WTAN030

ENG

Thank you for purchasing a Front Runner 42L Water Tank With Mounting System.

Before you start, take a moment to familiarize yourself with the Fitting Instructions and the components received. 

Refer to Page 2 for a list of all the components, quantities and tools required.

READ ME !

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD  
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT 
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND 
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO 
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY 
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.

Please call us if you have any questions about the installation of this product.

 Water Tank With 

 Mounting System 42L 

Содержание WTAN030

Страница 1: ... AND SECURING ALL FRONT RUNNER PRODUCTS TO YOUR VEHICLE CHECKING THE ATTACHMENTS PRIOR TO USE AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT WEAR AND DAMAGE THEREFORE YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS OR IF YOU HAVE NO MECHAN...

Страница 2: ...3MM 13MM IN THE BOX FIGURE 1 1 4mm 1 1 X Fuel Tank Yellow 2 1 X Strap 3 1 X M8 Eye Nut 4 1 X M8 x 30 Hex Bolt 5 2 X M8 Nut Cap 6 2 X M8 Nyloc Nut 7 3 X M8 X 16 x 1 6SS Flat Washer 8 2 X M8 x 20 Hex Bolt 9 2 X T Slot Rubber 300mm Long 1 8 9 10 5 2 3 7 6 8 GET ORGANIZED 1 ...

Страница 3: ... 2 2 3 Loosen and remove the corner of the Rack as shown Slide the M8 x 30 Hex Bolt Item 5 into the Channel as indicated by the arrow Line the Hex Bolt up with the center of the T Slot Beading from Step 2 1 Refit the corner Choose to mount your 42L Water Tank on either the front or back of the Slimline II The Tank must be positioned using either the front or rear slat Insert the two T Slot Beading ...

Страница 4: ...en off the Rack by removing the Plastic Cap loosening the M8 Eye nut and lifting the Tank Strap up and over as shown You will need to squeeze the Y Spring on the end of the Plastic Cap s retaining wire to release the Plastic Cap from the Tank Place the Tank with Tank Strap Item 2 onto the Rack as shown lining up the holes in the Tank Strap with the Hex Bolts inserted in Step 2 2 and 2 3 Ensure tha...

Отзывы: