5
TAKE A TRIP
After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where
needed. You'll find a small amount of settling has happened.
Go on many more adventures, periodically checking all nuts, bolts, screws and fittings.
(
)
A
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
Now's the time to visit your favorite Front Runner dealer in person or online.
(
)
A
Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle
manufacturer's recommendations.
REV_A01
With your rack still upside down from Step 3A, slide a M8x16 Hex Bolt into each end of all the Slats.
Grab your Friend and with one of you on each side of the Rack, flip the Rack end over end (Prevents the
Hex Bolts from falling out the machines slots) so that the M8x16 Hex Bolts are facing down. Approach the
vehicle from the rear, with the Wind Deflector facing forward. Lift the Rack up and over the Roof
positioning it above the two Side Rails. Bring the Rack down slowly, lining up the Bolts in the Rack with
the holes in the top of the Side Rails. Hand tighten the Rack to the Side Rails using the M8 Washers and
M8 Nyloc Nuts supplied.
Center the rack - left to right (check using a tape measure). Fasten all the Nuts and Bolts securing the
Rack and Side Rails to the vehicle. Place the M8 Nut Caps supplied over the M8 Nyloc Nuts.
(
)
B
FIT THE RACK...CONT.