Fronius WF 25i REEL R /SA/2R/G/W, Руководство по эксплуатации

Страница: 32 / 40

6
Reconnect the wirefeeding hose to the robot wirefeeder
Welding start depending on the application
7
To finish wirefeeding, press the Mode / Start button
Mode
Start
- The unreeling wirefeeder switches to threading mode, the "Wire retract" and
"Wire threading" buttons are active and can be used.
LED indicators in
normal operation When operating normally, the LEDs will flash green or will show a steady green.
Symbols used:
The LED is off
The LED is on
The LED is flashing
The LED flashes at approx. 2 Hz
The unreeling wirefeeder is not yet ready for use
or
the SR63 PC board is starting up
or
the UI-AVR PC board is in the process of being updated.
The unreeling wirefeeder is in threading mode.
Threading mode
The LED flashes at approx. 0.5 Hz
The unreeling wirefeeder is in threading mode and the "Wire thread-
ing" or "Wire retract" button is being pressed.
Only if OPT/i WF ext. installation set provided Start signal:
Torque mode selected on the unreeling wirefeeder, however torque
mode is not active.
The robot signal for the optional OPT/i WF ext. start signal is LOW.
Torque mode
Torque mode selected on the unreeling wirefeeder, torque mode is
active.
The robot signal for the optional OPT/i WF ext. start signal is HIGH.
32