Fronius TransSteel 3500 Rob, Руководство по эксплуатации

Страница: 57 / 104

57
EN
MMA welding
Safety
Preparations Move the mains switch to the - O - position
Unplug the device from the mains
Detach all cables to the wire-feed unit at the power source
Plug the grounding (earthing) cable into either the (-) or the (+) current socket, depend-
ing on the type of electrode, and latch it in firmly
With the other end of the earthing (grounding) cable, establish a connection to the
workpiece
Plug the bayonet current plug of the electrode holder cable into the free current socket
with the opposite polarity, according to the type of electrode, and twist it clockwise to
latch it in place
Plug in the mains plug
MMA welding
Move the mains switch to the "I" position: all the indicators on the control panel light
up briefly
Press the "Process" button to select the MMA welding process:
The welding voltage is connected to the welding socket with a 3-second time lag.
If the MMA welding process is selected, any cooling unit present is automatically de-
activated. It is not possible to switch it on.
Press the "Parameter selection" button to select the amperage parameter.
Use the adjusting dial to set the desired amperage.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
-
these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the machine is plugged into the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Do not carry out any work on the device unless
-
the mains switch is in the "O" position,
- the device is unplugged from the mains.
IMPORTANT! Check the rod electrode packaging to determine whether the rod elec-
trodes are for (+) or (-) welding.
1
2
3
4
5
6
7
CAUTION! Risk of injury and damage from electric shock. As soon as the mains
switch is in the "I" position, the rod electrode in the electrode holder is LIVE. Make
sure that the rod electrode does not touch any persons or electrically conducting
or earthed parts (e.g. the housing etc.)
IMPORTANT! Under certain circumstances, welding parameters that have been set
on a control panel of a system component (TR 2000 and TR 3000) may not be
changed on the control panel of the power source.
1
2
3
4