Fronius Robacta Reamer X-Line J, Руководство по эксплуатации

Страница: 63 / 76

Troubleshooting
Errors in the Pro-
gram Sequence
Parting agent is not injected
Parting agent container is full
Injection quantity too low
Extend injection time
Intake filter of the parting agent hose in the parting agent container is con-
taminated
Clean the suction filter of the parting agent hose with compressed air (for
more information, see section
Starting Up the Parting Agent Atomizer
from page 38 )
No signal from robot
Check robot program
Parting-agent injection nozzle blocked
Clean the parting-agent injection nozzle
Notify the service team (parting-agent injection nozzle needs replacing)
Vacuum pump defective
Contact service team (vacuum pump needs replacing)
Solenoid valve has mechanical fault
Contact service team (solenoid valve needs replacing)
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Welding torch has been poorly cleaned or is damaged
Position of the cleaning motor incorrectly set
Correctly set the position of the cleaning motor
Gas nozzle is clamped in incorrect position
Adjust the gas nozzle clamping device
Cleaning cutter does not fit the welding torch geometry
Fit a correct cleaning cutter
Cleaning cutter worn
Replace cleaning cutter
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
63
EN-US