Fronius Robacta Reamer V Twin, Руководство по эксплуатации

Страница: 33 / 92

Screwing the cleaning device to the underlying
surface
Screwing the
cleaning device
and installation
stand to the un-
derlying surface
NOTE!
Different fixings may be required to set up the installation stand depending on
the type of underlying surface (foundation).
Fixings are therefore not included in the scope of supply of the installation stand.
The installer is responsible for selecting the right type of fixing.
1
Place the optionally available installation stand on a level, firm and vibration-
free surface (foundation)
- Position the installation stand in such a way that the distance the robot
has to travel to the cleaning device on the installation stand is as short as
possible
2
Screw the installation stand to the underlying surface (foundation) using the
appropriate fixings
4 x
3
Position the cleaning device on the
installation stand
4
Position the spatter tray on the
cleaning device as shown
5
Securely screw the cleaning device
and spatter tray to the installation
stand as shown. Use the fixings
supplied with the cleaning device
Screwing the
cleaning device
to the underlying
surface
NOTE!
Different fixings may be required to set up the device depending on the type of
underlying surface (foundation).
The fixings supplied may only be used on an underlying surface (foundation)
thickness of 5 mm (0.197 in.) or less.
Do not use the fixings supplied to set up the device on an underlying surface
(foundation) thickness greater than 5 mm (0.197 in.). In this situation the in-
staller is responsible for selecting the right type of fixing.
1
Place the cleaning device on a level, firm and vibration-free surface (founda-
tion)
- Position the cleaning device in such a way that the distance the robot has
to travel to the cleaning position is as short as possible
33
EN