Fronius Robacta Reamer V Twin, Руководство по эксплуатации

Страница: 30 / 92

WARNING!
Danger from power supply and/or compressed air supply to the cleaning device!
The following conditions can lead to serious injuries:
rotating cleaning cutters
lifting device moving up/down
extending/retracting gas nozzle clamping device
activated wire cutter
flying parts (shavings, etc.)
compressed air/parting agent mixture escaping from the parting-agent injection
nozzle
If work has to be performed on the cleaning device while it is being supplied with
voltage and/or compressed air:
▶
keep your body, especially your hands, face, hair, any objects and all clothing
away from the cleaning cutter, lifting device, gas nozzle clamping device, wire
cutter and parting-agent injection nozzle
▶
Wear ear protection
▶
Wear protective goggles with side protection
Ensuring that
the cleaning
device is depres-
surised
Attempt to briefly activate the cleaning device without any compressed air sup-
ply to check whether the cleaning device is depressurised. Proceed as follows:
1
Take protective measures:
- The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter
and parting-agent injection nozzle could start up. Therefore keep your
body, especially your hands, face and hair, any objects and all clothing
away from the parts referred to above
- Wear ear protection
- Wear protective goggles with side protection
2
Ensure that the cleaning device has been disconnected from the compressed
air supply
3
Briefly turn the "Lifting device up/down" screw on the Robacta Reamer V
Twin 90° to the right, then turn it straight back to its original position.
- If the cleaning device does not respond to the turning of the screw, the
cleaning device is depressurised
- If the cleaning device responds to the turning of the screw, the cleaning
device is still connected to a compressed air supply. If this is the case, you
must disconnect the cleaning device from the compressed air supply and
check again that the cleaning device is depressurised before starting work
30