Fronius RCU 5000i, Инструкция по эксплуатации и запасные части

Страница: 142 / 248

142
Documentation
on memory card If the "Doc. on SD card" parameter is set to "On", the actual welding values are buffered in
the cache memory and stored on the remote control memory card.
"Warning - Please insert a memory card" screen
If there is no memory card in the memory
card slot (24), the "Warning - Please insert
a memory card" screen appears.
A regular card reader is required for reading
data from the memory card.
Memory require-
ments for docu-
mentation on
memory card The memory requirements for documentation on the memory card depend on the param-
eters "Every n-th seam" and "Every n seconds" as well as the power source's duty cycle.
The following table shows guideline values for the amount of time it takes to fill a 32 MB
memory card.
0.2 The actual welding values are documented every 0.2 seconds
... ...
9.9 The actual welding values are documented every 9.9 seconds (maxi-
mum)
e.g. in the case of long welds
A common value for the "Every n seconds" parameter is 0.5 sec.
Job documentation
for activating/deactivating the documentation function for a selected job
Range
Off/on/per job
Off In job welding, the actual welding values are not documented, regardless
of what is stored in the job concerned
On In job welding, the actual welding values are documented according to
the parameters in the "Basic settings" screen
Job-specific In job welding, the actual welding values are documented according to
the documentation parameters stored in the job concerned
Doc. on SD card
for activating/deactivating whether welding data are stored on the memory card
Range
Off/On
Off The actual welding values are not stored on the remote control unit mem-
ory card.
On The actual welding values are buffered in the cache memory and stored
on the memory card.
Please insert a memory
card
IMPORTANT! The memory card must not
be write-protected.