Fronius LaserHybrid Ultracompact Twin, Руководство по эксплуатации

Страница: 24 / 120

24
Requirements
System require-
ments and mini-
mum equipment
required for the
laser-twin weld-
ing process (1) LaserHybrid Ultracompact Twin welding head
(2) LaserHybrid Ultracompact Twin hosepack
(3) Two unreeling wirefeeders
WF 25i REEL R /SA/2R/G/W (stand-alone)
+ OPT/i WF wire straightening section option (4,100,880,CK)
(4) Two power sources
TPS 5000 (+ variants)
+ Official UST V3.10.33 firmware and higher
+ LHSB connection option
+ "TimeTwin Digital" software activation
+ Software update from the Fronius database
+ Standard I/O robot interface or fieldbus
The options are required on both power sources.
(5) Drive Easy Twin control box
(6) Cooling unit
FK 9000 R (2-part)
Power source
synchronisation The power sources are synchronised with one another during the laser-twin welding pro-
cess via:
-
The LHSB connection option on the power sources
- The LHSB connection cable
The P-C (Power-Control) parameter is available following successful installation of the
LHSB connection. The P-C parameter is displayed on the power source under Setup menu
- Level 2.
Possible settings:
On / oFF
Software activa-
tion Activation of the "TimeTwin Digital" software (item number 4,061,110) is required on both
power sources for the laser-twin welding process.
The t-C (Twin-Control) parameter is available following successful activation and estab-
lishment of an active LHSB connection. The t-C parameter defines the lead power source.
This power source specifies the frequency for the trail power source.
IMPORTANT! Software activation on the power sources is monitored via the LHSB con-
nection. If the software is not activated on a power source and the t-C parameter is there-
fore not available, the t-C parameter is also not displayed on the other power source.
Possible settings:
On / oFF
NOTE! For the laser-twin welding process, the P-C parameter must be set to "On"
on both power sources.