23
EN
Connect the cold wire feeder to the power source
General
The cold wire feeder is connected to the power source using the interconnecting hosepack.
Connect the cold
wire feeder to the
power source
WARNING!
Danger from incorrect installation
This can result in serious injury and damage to property.
► Do not carry out the steps described here until you have read and completely under
-
stood all the Operating Instructions
Switch the power source mains switch to the "Off" position
Open right side panel of the wirefeeder:
-
Loosen the 2 screws
-
Swing side panel upwards
If the welding torch has a conventional control plug instead of a LocalNet connection
socket:
-
Remove blanking cover (1) for bushing (3)
Feed control socket (4) through bushing (3)
-
Remove blanking cover (1) for bushing (3)
Plug control plug (5) into torch control connection (4)
Plug welding potential bayonet plug (6) into current socket (2) and turn to fasten it
Plug LocalNet (7) plug into LocalNet port (10)
Tighten union nut on LocalNet plug (7)
If available, connect water flow and water return hoses to plug connectors (8) and (9),
ensuring that colours are matched
Close right side panel of the cold wire feeder:
-
Swing side panel down
-
Fix side panel in place with 2 screws
)
6
(
)
5
(
)
4
(
)
3
(
)
2
(
)
1
(
(7)
(8)
(9)
(10)
1
2
3
4
5
6
7
8
9
10
