Fronius FDV 15 MF, Руководство по эксплуатации

Страница: 27 / 44

25
IMPORTANT! For each workpiece a corresponding welding program must be created.
This contains a list of welding parameters that is saved under a specific program number
(job number). These programs can be reloaded at any time, and corrected as required.
The programs are managed from the power source control panel. When an analogue
power source is used, the requisite welding parameters must be set manually on the
power source.
Load the relevant welding program on the control panel for the power source. More de-
tailed information on managing welding programs can be found in the operating instruc-
tions for the power source.
Loading a weld-
ing program
Start-up
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read
and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
The following activities and work steps apply to the installed system. All connections
must be established. Before start-up, check the connections of the following system com-
ponents:
- Power source
- Cooling circuit
- Gas cylinder
- Wire-feed unit
- Welding torch with hosepack
- Workpiece
Precise information on the assembly and connection of the system components can be
found in the relevant system component operating instructions.
Check the
connections
IMPORTANT! There are no fixed rules for the sequence in which the system compo -
nents are switched on. They can be switched on in any order.
On the following system components turn the main switch to the "ON - 1" position:
- Driving vehicle control unit
- Power source
- Wire-feed unit (if power is not supplied from the power source)
Switch on
system compo-
nents
Carry out the following settings for the welding process:
- Traversing speed
Define driving
vehicle param-
eters