Fronius DeltaSpot G2, Инструкция по эксплуатации и список запасных частей

Страница: 29 / 68

29
EN
J Reset error
K Power source OK
L Current actual value signal
M GND current actual value
N Status "1"
P Status "2"
R Status "4"
S Status "8"
T Status "16"
X5 External welding start
for starting the welding process externally without Hold to Run function
Pin assignment:
A
SAFETY CIRCUIT_B1
B SAFETY CIRCUIT_B2
C + 24 V output for initiating welding start-up
D 24 V feedback signal for welding start-up initiation
E Prog. no. 0-1
F Prog. no. 2-3
G Prog. no. 4-7
H Prog. no. 8-15
I Prog. no. 16-31
J Prog. no. 32-63
K Prog. no. 64-127
L Prog. no. 128-255
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
The design of external operating equipment or Emergency Stop actuators must comply
with applicable national and international standards.
X6 Analogue power source connection socket
for connecting analogue power source signals
Assign-
ment
Colour Connection cable
A Yellow (+) pin secondary voltage, welding transformer
B Green (-) pin secondary voltage, welding transformer
C White (+) pin secondary current measurement (Rogowski coil)
D Brown (-) pin secondary current measurement (Rogowski coil)
E Green/
yellow Current measurement shield
F Pink (+) pin welding current set value (0 - 10 V)
G Grey (-) pin welding current set value (0 - 10 V)
X7 Reset for safety relay and output for undervoltage cut-out
1 RESET_A1
2 RESET_A2
3 U<CUT-OUT_1
4 U<CUT-OUT_2