Fronius Cleaning Unit TC 2000, Руководство по эксплуатации

Страница: 46 / 68

46
Start up the Cleaning Device
General
To achieve optimum cleaning results, observe the following points:
-
Always wet the inside of the welding torch with parting agent
- Adhere to the specified cleaning procedures
- Adhere to the specified cleaning positions
- Blow out the welding torch with compressed air during cleaning (but not while parting
agent is being injected into the inside of the welding torch)
Requirements for
Commissioning The following requirements must be met in order to commission the cleaning device:
-
Base unit screwed tightly to the surface
- Cleaning unit screwed tightly to the surface
- Interconnecting hosepack of cleaning unit connected to the base unit
- Base unit connected to the grid
- Base unit supplied with compressed air
- Base unit connected to the robot control
Only if present/used
-
‘Robacta Reamer’ parting agent container connected to the cleaning unit
- Wire cutter installed and supplied with compressed air
NOTE! If wetting agent has not been applied to the inside of the welding torch,
this may lead to the permanent contamination of the welding torch when welding
begins. Always wet the inside of the welding torch with the manufacturer’s ‘Ro-
bacta Reamer’ parting agent before starting an automatic mode.
NOTE! Individual small spatters are not removed by the cleaning device. Small
welding spatters do not, however, affect the welding process.