Color Screen Weather Station User Manual
5. Date
16. Max outdoor humidity
6. Moon phase
17. Indoor temperature
7. Weather forecast icon
18. Max indoor temperature
8. Absolute/relative barometric pressure selection
19. Min indoor temperature
9. Barometric pressure
20. Indoor humidity
10. Outdoor sensor signal
21. Min indoor humidity
11. Outdoor temperature
22. Max indoor humidity
23. MAX/MIN DAILY icon
3.3.3 Sensor Operation Verification
Verify the indoor and outdoor humidity match closely with the console and sensor array in the
same location (about 10’ apart). The sensors
should be within 10% (the accuracy is ± 5%). Allow
about 30 minutes for both sensors to stabilize.
Verify the indoor and outdoor temperature match closely with the console and sensor array in
the same location (about 10’ apart). The sensors should be wit
hin 4°F (the accuracy is ± 2°F).
Allow about 30 minutes for both sensors to stabilize.
4.
Sensor Placement
It is recommended you mount the remote sensor outside on a north facing wall, in a shaded area,
at a height at or above the receiver. If a north facing wall is not possible, choose a shaded area,
under an eve.
Direct sunlight and radiant heat sources will result in inaccurate temperature readings. Although
the sensor is weatherproof, it is best to mount in a well-protected area, such as an eve.
1. Use a screw or nail to affix the remote sensor to the wall, as shown in Figure 6
2. Hang the remote sensor up on string, as shown in Figure 7.
Figure 6 Figure 7
Note:
Make sure the sensor is mounted vertically and not lying down on a flat surface. This will
insure optimum reception. Wireless signals are impacted by distance, interference (other
weather stations, wireless phones, wireless routers, TVs and computer monitors), and
transmission barriers, such as walls. In general, wireless signals will not penetrate solid metal and
