- 3 -
displayed time and weather data on a PC.
Important Operation Notes
All actions and functions of the weather station are started on the touch screen
by slightly touching (not pressing!) the related areas, touch the flashing
+
,
ON/OFF or
–
to make the corresponding selection or increase the value.
Every time a programming step is activated by touching a switching area on the
Touch Screen a tone will sound, and the back light is switched on for a few
seconds as well.
If no areas are pressed for 30 seconds, the LCD will automatically revert to the
normal display mode (automatic time out).
Set up Guide
Before placing and installing all components of the weather station at there
final destination, please set up the weather station with all parts being nearby
for testing the correct function.
Setting up the base station and transmitter
Insert two pieces of LR6 (AA size) batteries into the transmitter, the LED
located in the middle front case of transmitter will be turned on for 4 seconds,
then it will be off and start to work normally. The transmitter will make a data
transmission and then start radio controlled time reception routine. If time
signal can be detected correctly, the LED will start to flash 5 times, and then
the LED will be on for 20s,
indicating time signal has been found correctly.
When time signal is bad and reception is not possible, the transmitter will
terminate radio controlled time reception within one minute and resume
normal mode. When there is a data transmission happened, the LED will be
on for 20ms. During radio controlled time reception period, there is no
transmission and normal transmission will only resume after time reception
routine is complete. The longest time for radio controlled time reception is 5
minutes.
After inserting the batteries into the Weather Station, all LCD segments will
be turned on for a few seconds, all possible display segments are turned on
for checking.
After this, the weather station will make initial measurement and start to
register the transmitter (the radio reception icon will be turned on). Do not
press any key before outdoor sensor data received, otherwise the outdoor
sensor learning mode will be terminated. When outdoor transmitter has been
registered, the base station will automatically switch to the normal display
