Frigidaire Sprigfield Series Gas Range, Руководство пользователя

Страница: 13 / 16

13
To Remove and Replace Oven Bottom
To Remove Oven Bottom:
1. Remove the oven racks.
2. Remove the two hold-down screws (Figure 1) at the rear of the oven bottom
panel. If the screws are too tight to remove by hand, use a screwdriver.
3. To lift out the bottom panel, place fingers in the slots in the bottom. Lift the
rear of the panel up and back until it is clear of the lip at the front of the panel
(Figure 2).
4. Lift the bottom up and out.
To Replace the Oven Bottom:
1. Place the oven bottom in the oven with the back raised about 6" or until you
can insert the front of the oven bottom under the hold-down lip at the front
of the panel.
2. Push the back of the oven bottom down fully into place on the metal flanges
and insert the hold-down screws.
General Cleaning
(continued)
To Remove and Replace Oven Door
To Remove Oven Door
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges (one
on each side).
3. Close the door to the quarter-open position. Grasp the door firmly on both
sides and lift up and off the hinges.
4. To clean oven door, follow the instructions provided in the cleaning chart
under General Cleaning .
To Replace Oven Door
1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at
the bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4. If the door is not in line with the oven frame, remove it and repeat the above
steps.
5. Replace screws previously removed.
Figure 1
Figure 2
The door is heavy. For
safe, temporary storage, lay the door
flat with the inside of the door facing
down.
Be sure the range is
unplugged and all parts are COOL before
replacing the surface or oven lights.
Wear a leather-faced glove for
protection against possible broken
glass.
Changing Oven Light
(some models)
To Change the Oven Light (some models)
1. Turn electrical power off at the main source or unplug the range.
2. Replace bulb with a new 40 watt appliance bulb.
3. Turn power back on again at the main source (or plug the range back in).
4. The clock (if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner’s Guide.