Frigidaire RC30DG60PS, Инструкция по использованию и уходу

Страница: 6 / 16

Setting Surface Controls
Burner Cap
Burner Head
Fig. 1
Fig. 4
Correct Burner Cap
Placement
Fig. 2
Incorrect Burner Cap
Placement
Fig. 3
Burner Cap Lip
Check Burner Cap Placement Before
Operating the Surface Burners
To prevent fl are-ups and avoid creation of harmful by-
products,
DO NOT use the cooktop without all burner caps
properly installed to ensure proper ignition and gas fl ame
size.
It is very important to be sure that all surface burner caps
and burner grates are properly installed and in the correct
locations
BEFORE operating the cooktop burners.
Remember:
• Always keep surface burner caps in place whenever
using a surface burner.
• When placing the burner caps, be sure that all burner caps
are seated fi rmly and rest level on top of burner heads.
• For proper fl ow of gas and ignition of burners DO NOT
allow spills, food, cleaning agents or any other material to
enter the gas orifi ce port opening.
Round Style Burners
The burner cap lip (See Fig. 1) should fi t snug into the
center of burner head and rest level. Refer to Figs. 2 & 3
for correct and incorrect burner cap placement. Once in
place, you may check the fi t by gently sliding the burner
cap from side to side (Fig. 4) to be sure it is centered and
fi rmly seated. When the burner cap lip makes contact inside
the center of the burner head you will be able to hear the
burner cap click. Please note that the burner cap SHOULD
NOT move off the center of the burner head when sliding
from side to side.
Fig. 5
Bridge Burner Head
Bridge
Burner
End
Cap
Bridge
Burner
End
Cap
Bridge
Burner
Center
Cap
Igniter
Hole
Igniter
Hole
Bridge Style Burners
Install Burner Caps, these include one Bridge Burner
Center Cap (rectangular shaped) and the two Bridge Burner
End Caps (The Bridge Burner End Caps will fi t either the
front or rear Bridge Burner Head locations). Make sure
that the lips located under the Bridge Burner Caps fall into
the slots located in the Bridge Burner Head (See arrows in
Figure 5) and that all the Bridge Burner Caps lie fl at and
evenly on the Bridge Burner Head.
6