4
Instructions for Use
This fireplace can be operated with the switches located on the rear panel of the fireplace.
Plug the fireplace to an power outlet.
The controls are located on the rear panel of the fireplace .The ON/OFF switch must be first
switched ON. This will turn the flame effect ON.
Turn the
I
button ON for low heat.
Turn the
I
&
II
button ON for high heat.
Safety Cut-Off
This fireplace is equipped with safety cut-off feature, which will operate if the fireplace
overheats (e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT
automatically reset, and will need to be turned ON manually.
To reset the Fireplace, disconnect the fireplace from the power port for at least 15 minutes.
Reconnect to the power port and switch on the fireplace.
Troubleshooting
Problem
Possible Solution
Unit doesn’t work / doesn’t heat
·
Check if the unit is plugged in the power port
·
Check if the unit is in Standby mode. Turn the
unit ON.
·
Check if heat is turned OFF.
·
Check for safety cut-off operation.
