29
To Clean the Recessed and Contoured Well Areas of the Cooktop -
If a spill occurs on or in the recessed or contoured
areas, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry.
To Clean the Surface Burner Grates, Caps & Surface Burner Drip Pans
(some models)
-
Use a soap-filled scouring
pad or a mild abrasive cleanser to clean the surface burner caps and surface burner drip pans (if equipped).
Please Note: THE COOKTOP IS NOT REMOVABLE.
Do not attempt to remove or lift the cooktop.
General Care & Cleaning
Any additions, changes or conversions
required in order for this appliance to satisfactorily meet the
application needs must be made by an authorized
Electrolux
Distributor or Qualified Agency.
Cleaning the Cooktop
The cooktop is designed to make cleaning easier. Since the four burners are sealed, cleanups are easy when spillovers
are cleaned up immediately. To clean, wipe with a clean, damp cloth and wipe dry.
DO NOT
attempt to clean the cooktop
when the cooktop or burner heads are still hot. The contoured well areas and burner drip pans (some models) should be
routinely cleaned. Keeping the burner head ports and slots clean will prevent improper ignition and an uneven flame. Refer
to the following sections for further instructions.
To clean the burner head ignition ports -
Each burner head has a small
ignition port located as illustrated. Should you experience ignition problems it
may be that this port hole is partially blocked with soil. With the burner head in
place, use a small wire gauge needle or the end of a paper clip to clear the
ignition port.
To Clean the Surface Burner Heads
- For proper gas flow it may be necessary
to clean the burner head and slots. To clean, first use a clean DAMP cloth to
soak up any spills. Remove any food from between the burner slots using a small
non-abrasive brush like a toothbrush and afterwards wipe up using a damp cloth.
For stubborn soils located in the slots, use a small-gauge wire or needle to clean
the slots.
Please Note:
The surface burner heads are secured to the cooktop and must be
cleaned in place on the cooktop.
ignition port
slots
orifice port
Cooktop Burner Head
DO NOT
attempt to clean the cooktop when
the cooktop or burner heads are still hot. Touching hot
cooktop areas, burner grates and burner caps can cause
burns.
For proper flow of gas and ignition of the burner —
DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY
OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS
keep the surface burner cap and
surface burner head in place whenever a surface burner is in use.
