11
Do not overload washer. See
Washing
Procedures.
Rearrange load to allow proper spinning.
Straighten drain hose.
Check another faucet in the house. Wait until
water supply and pressure increase.
Fully open hot and cold faucets.
Water pressure must be at least 30 psi (260
kPa). Avoid running water elsewhere while
washer is filling.
Straighten hoses.
Select higher water level/load size.
Do not overload washer. When control is set at
highest fill level, dry load level should not be
higher than top row of circular holes in wash
tub.
Measure hot water temperature at nearby
faucet with candy or meat thermometer. Water
temperature should be at least 130°F (70°C).
Adjust water heater as necessary.
Avoid using hot water elsewhere before or
during washer use. There may not be enough
hot water available for proper cleaning. If
problem persists, your hot water system may
be unable to support more than 1 use at a time.
Clean and straighten the drain hose.
Check and tighten hose connections. Install
rubber sealing washers provided.
Unclog drain pipes. Contact plumber if
necessary.
Use less detergent.
Connect hot water hose to hot water faucet
and cold water hose to cold water faucet.
Standpipe must be a minimum of 33" (83.82
cm) high to prevent siphoning. See
INSTALLATION INSTRUCTIONS.
SOLUTION
Wash load too wet after
spin.
Water does not enter
washer or it enters
slowly.
Water level does not
cover load.
Warm or hot water is not
hot enough.
Water in washer does not
drain or drains slowly.
Water leaks.
Incorrect wash and rinse
temperatures.
Water is entering washer
but tub does not fill.
OCCURRENCE
WATER
POSSIBLE CAUSE
Washer is overloaded.
Load is out of balance.
Drain hose is kinked.
Water supply is not adequate in area.
Water supply faucets are not completely
open.
Water is being used elsewhere in the house.
Water iinlet hoses are kinked.
Improper water level selection (for models
with water level/load size control).
Washer is overloaded.
Hot water heater is set too low or is a distance
from washer.
Hot water is being used elsewhere in the
house.
Drain hose is kinked or clogged.
Fill hose connection at faucet or washer.
House drain pipes are clogged.
Oversudsing
Hot and cold water hoses are connected to
wrong supply faucets.
Drain hose standpipe is incorrect height.
