Frigidaire FMV156DB, Руководство по установке

Страница: 5 / 8

5
Installation Instructions
8 VENTILATION SYSTEM
(PREPARING OVEN FOR INSTALLATION)
(C) VERTICAL EXHAUST: OUTSIDE VENTILATION
1. Remove and save 2 screws from back edge and 3 screws
from the top center of the Fan Cover Bracket. Remove Fan
Cover Bracket by sliding it in the opposite direction of the
arrow on the Fan Cover Bracket as shown in Figure 11.
2. Lift Hood Fan Unit carefully and slip wires out of cavity. See
Figure 12.
Caution: Do not pull or stretch hood fan wiring.
3. Rotate the Hood Fan Unit 90˚ so that the fan blade openings
are facing the top of the oven. See Figure 13 (A). Replace
Hood Fan Unit into the oven. Be careful not to pinch the lead
wire between the inner bracket and the Hood Fan Unit. Put
the lead wire into Wire Box. See Figure 13 (B).
4. Replace the Fan Cover Bracket by sliding it into the slits in
the same direction as the arrow on the Fan Cover Bracket.
Make sure the fan blades are visible through the top open-
ings in the oven before proceeding.
5. Attach the Fan Cover Bracket to unit with the 2 screws from
back edge and 3 screws from the top center of the Fan
Cover Bracket, which were removed in Step 1 above. See
Figure 14. The Hood Fan Unit is now rotated for vertical
exhaust operation.
6. Attach the Exhaust Damper Assembly
9
to the fan cover on
the top of the outercase cabinet by sliding it into the slits in
the same direction as the arrow. Use 1 Tapping Screw 4 X12
mm
5
from the INSTALLATION HARDWARE and tighten
into place. See Figure 15.
9 OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT
REFERRING TO THE MOUNTING INSTRUCTIONS FOUND
ON WALL AND TOP CABINET TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING
INFORMATION ON WALL AND TOP CABINET TEMPLATES.
THIS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL
STUD. SEE WALL CONSTRUCTION ON PAGE 6.
WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING
SCALE PLATE SECTION.
MOUNTING SCALE PLATE
Attach 2 Scale Plates
!
with tape (not included). See Figure 16
and WALL TEMPLATE for locations.
Figure 11
Figure 14
Figure 12
Figure 13
(A) Rotate 190˚
(B)
Figure 15
Exhaust Damper Assembly
Figure 16
Scale Plates
Mounting Plate