Frigidaire FHPC102AC1, Инструкция по использованию и уходу

Страница: 6 / 28

6
IMPORTANT SAFETY INSTRUCTIONS
Normal Sounds
1
2
3
4
High pitched Chatter
Today’s high efficiency compressors
may have a high pitched chatter during
the cooling cycle.
1
Sound of Rushing Air
At the top of the unit, you may hear the
sound of rushing air being moved by
the fan.
2
Gurgle/Hiss
“Gurgling or hissing” noise may be
heard due to refrigerant passing
through evaporator during normal
operation.
3
Vibration
Unit may vibrate and make noise
because of uneven floor.
4
• Do not use this device to turn the unit on
or off.
• Always make sure the RESET button is
pushed in for correct operation.
• The power supply cord must be replaced
if it fails to reset when either the TEST
button is pushed, or it cannot be reset. A
new one can be obtained from the
product manufacturer.
• If power supply cord is damaged, it
CANNOT be repaired. It MUST be
replaced by one obtained from the
product manufacturer.
READ THIS SECTION BEFORE ATTEMPTING
TO OPERATE AIR CONDITIONER.
Unit must be upright for one hour prior to
operating.
The unit should be operated in a
temperature range of 60°F - 95°F (16°C -
35°C) when in cool mode and 41°F - 90°F
(5°C - 32°C) when in heat mode.
Performance may be reduced outside of
these operating temperatures.
Operation of Current Device
The power supply cord contains a current
device that senses damage to the power
cord. To test your power supply cord do the
following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO
buttons on the plug head. Press the TEST
button. You will notice a click as the
RESET button pops out.
3. Press the RESET button. Again you will
notice a click as the button engages.
4. The power supply cord is now supplying
electricity to the unit. (This is also
indicated by a light on the plug head).
Plug in & press RESET
corrode the copper pipe-work.
NOTE Examples of leak detection fluids are
– bubble method,
– fluorescent method agents.
If a leak is suspected, all naked flames shall
be removed/extinguished.
If a leakage of refrigerant is found contact
local manufacter to replace unit.