Operating Instructions
In this mode, the “ ” or “ ” button is disabled and the screen will remain blank. The unit will continuously
drain moisture from the room.
Do NOT switch the unit off by removing the plug.
Press the “Cool” button to activate the cool mode.
Press the “Dry” button to activate the dry mode.
Press the “FAN” button to activate the Fan mode.
Press the “ fan speed” button to choose the fan speed “auto”, “high” and “low”.
Press the “ ” and “ ”button to choose the temperature you want.
In this mode, you can select fan speed “high” or “low” by pressing the Fan speed button and referring to
the diagram.
Note: In this mode, the air exhaust hose does not need to be connected.
How to Use the Remote Control
TURNING THE UNIT ON
Cool mode
Dry mode
Fan mode
Note:
In this mode, the fan speed will be set as “low” automatically, which cannot be changed.
In this mode, condensate drainage are required, refer to the "Drainage Instructions" on Page 14 for more
instructions to drain the excess condensate.
Plug in the unit, then press the “ ” button (when turned on, the unit will operate as the last setting
before shutdown.
To switch the unit off, press “ ” button again, then remove the plug.
Always switch the unit off by pressing the “ ” button and wait for few minutes before removing the plug.
Press the “Auto” button to activate the auto mode.
Press the “ ” and “ ” button to choose the temperature you want. In this mode, the unit will automatically
select cooling, heating(not applicable for cooling only models), or fan only operation depending on what
temperature you have selected and the room temperature. The air conditioner will control room temperature
automatically round the temperature point set by you.
Note: In this mode, fan speed cannot be selected.
Auto mode
