Frigidaire FGPC1044U1, Инструкция по использованию и уходу

Страница: 8 / 15

(continued)
2009 Electrolux Home Products, Inc. All rights reserved.
Installation in a double-hung sash/sliding sash window
3.
Press back the locking lever to fix the longth of the window slider kit then
close the window sash securely against the window slider kit (Fig. 12).
5. Cut the foam seal B(adhesive type) to an appropriate length and seal the open gap between
the top window sash and outer window sash, as shown in Fig. 14.
6. Cut the decoration film to an appropriate length and stick on the extending
rod channel(Fig. 15).
2. Open the window sash and lift the locking lever of the window slider kit (Fig. 9), then place the window slider kit on the
window stool. Adjust the length of the window slider kit according to the width of window (Fig. 10).
1. Cut the foam seals A(adhesive type) to the proper lengths and attach them to the window and stool (Fig. 8).
Fig. 8
Foam seal A
(adhesive type)
Installation Instructions
Installation Instructions
4.
To secure lower sash, attach sash lock with 3/8
”
(9.5mm)
screw as shown Fig. 13.
NOTE:
It is difficult to lock the windows with the sash lock for Vinyl-Clad
windows, so you can use lock by window itself.
Fig. 13
Sash lock
Fig. 14
Foam seal B(adhesive type)
8
Fig. 10
Window
slider kit
Fig. 12
Fig. 15
Decoration
film
Fig. 9
Locking lever
Fig. 11 A Fig. 11 C Fig. 11 B
NOTE:
If the window is too wide, you can replace the pre-installed telescopic rod with the spared extend rod or
combine the 2 rods. The recommended usage of the rods are as below:
t8JUINNQSFJOTUBMMFEUFMFTDPQJDSPEPOMZBWBJMBCMFSBOHFNNNN
t8JUINNTQBSFEFYUFOESPEPOMZBWBJMBCMFSBOHFNNNN
t8JUIUIFDPNCJOBUJPOBWBJMBCMFSBOHFNNNN
To replace the pre-installed telescopic rod with the spared extend rod, first take out the telescopic rod
completely(Fig.11 A). Then take down the cap from the pre-installed telescopic rod and put it on the spared extend
rod.
To combine the 2 rods, first take out the telescopic rod completely(Fig.11 A). Then align the 3 hooks on the extending
rod to the 3 slots on the end of the telescopic rod and slide the 3 hooks into the slots, then press down the extending
rod to lock the slots(Fig.11 B). After that slide the combined telescopic rod back into the window kit(Fig.11C).