Frigidaire FGPC1044U1, Инструкция по использованию и уходу

Страница: 7 / 15

Installation Instructions
2009 Electrolux Home Products, Inc. All rights reserved.
Installation Instructions
EXHAUSTING HOT AIR
1. Extend either side of the hose (Fig. 3).
2. Slide the adaptor A into the excharge hole of the unit as shown on Fig. 4.
3. Install the window kit on the window and slide the adaptor B into the
window slider kit and seal. (Fig. 5 & 6)
In the COOLING Mode the appliance must be placed close to a window or
opening so that the warm exhaust air can be ducted outside.
First position unit on a flat floor and make sure there’s a minimum of 12"
clearance around the unit, and is within the vicinity of a single circuit outlet
power source.
Fig. 3 Extend the side of hose
Adapter B Adapter A
NOTE:
Refer to page 8 about how to install the window kit.
The hose can be extended from its original length of 15" up to 59", but it is the best to keep the length to minimum required.
Also make sure that the hose does not have any sharp bends or sags. (Fig. 7)
Fig. 5
Window Slider Kit
Minimum:22.1"(560mm)
Maxmum:44.1"(1120mm)
Vertical
window
Fig. 7
Fig. 6
Window Slider Kit
Horizontal
window
Fig. 4
Minimum:22.1"(560mm)
Maxmum:44.1"(1120mm)
7