26
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system.
Systems certified for cyst reduction may be
used on disinfected waters that may contain
filterable cysts.
Test & certification results:
• Rated Capacity - 125 gallons/473 liters
for
PureSource
Ultra II
TM
ice and water
filter
• Rated service flow - .65 gallons per
minute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace the PureSource Ultra II
TM
water filter:
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe up
any small amounts of water released during
the filter replacement. (Instructional video of
procedure can be found on www.frigidaire.com.)
1 Push down on front edge of filter cover.
Cover will tilt down and expose water
filter.
2 Remove the old filter by rotating it
counter-clockwise (to the left) 90 degrees
to release it.
3 Slide the old filter cartridge straight out of
the housing and discard it.
4 Unpackage the new filter cartridge. Slide
it into the filter housing as far as it will go
with the grip end horizontal.
5 Push lightly inward on the filter while
rotating it clockwise (to the right). The
filter will then pull itself inward as it is
rotated. Rotate the filter 90 degrees until
it stops and the grip end is vertical. A very
light click may be heard as the filter locks
into place.
The
PureSource Ultra II
TM
ice and water filter system is
tested and certified to NSF/ANSI
Standards 43, 53 and 401 for the
reduction of claims specified on
the performance data sheet.
More about the Advanced Water
Filter
CHANGING THE FILTER
6 Press a drinking glass against the water
dispenser while checking for any leaks at
the filter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7 Continue dispensing water for 3-4
minutes. It may be necessary to empty
and refill the container several times.
8 Press and hold the
Reset Water Filter
button on the display for three seconds.
When indicator is no longer illuminated,
the water filter status has been reset.
9 Replace filter cover by pushing up and
snapping into place.