background image

READ BEFORE INSTALLING UNIT

MSII 

MSIII 

Window Mounting (5,000~8,000 BTU)

1

Installation Instructions

Before installing, the top rail must be assembled on the unit.

DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE.

NOTE:

SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is
the best way to store unit during winter, or when not 
in use.

FOR SAFETY REASONS, THE TOP RAIL MUST BE
SECURELY FASTENED WITH ALL FOUR (4) 
SCREWS.

A. Remove the air conditioner from the carton and place on a flat surface.
B. Remove top rail from the rear of the packaging material as shown in Fig. A
C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B
D. Secure the top rail to the unit with the 3/8

Ǝ

 Screws as shown in Fig. C

Top Rail Hardware

Qty.

4

1

3/8

Ǝ

 Screw

Top Rail

Some assembly is required. Please read these instructions
carefully. 

Packaging

Fig. A

The unit is for window mounting only.

INSTALLATION WARNINGS AND CAUTION

Pay attention to danger and safety notices.

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may 
be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install 
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To 
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended 
period of time.
Handle air conditioner with care. 
Make sure air conditioner does not fall during installation.

Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.

Drill (If pilot holes are needed)

7

1

Mounting Hardware

Qty.

2

s)

2

( or Wooden windows)

weather stripping

insulation panel

ruler

(10”X3/4”X1/12”)

5

window sash seal foam

1

2

1

1

2

3

4

5

6

7

8

9

10

11

12

1

2

3

4

5

16120300A04442

Top Rail

Содержание FFRE0833S1






Отзывы: