Cycle Selection Options
SER
V
ICE
D
A
T
A
S
HEET
P/N:
15
44
4818
3
5
88
3
33
01
Color Code
BK......................... Black
BU............................Blue
PK............................Pink
R...............................Red
R-BK...............Red/Black
R-Y................Red/Yellow
VIO.........................Violet
W...........................White
Wiring Diagram
Display Codes (LED)
To start
To delay start
Close and latch door. Press START/CANCEL pad.
Close and latch door. Press DELAY START pad to select desired
delay time.
To select a new
cycle or option
Press desired cycle and/or option pad. The indicator lights will change. Press
START/CANCEL within 15 seconds to begin cycle.
To cancel cycle
Press START/CANCEL. Dishwasher will drain for 90 seconds, then shut off.
WASHING
SANITIZED
DRYING
CLEAN
OPTION LED's Flashing
STATUS LED's Flashing
---------------------- Wash portion of cycle.
-------------------- The SANITIZED criteria has been met. Indicator light will switch off when door is opened.
------------------------ Drying portion of cycle.
------------------------ Shows completion of cycle. Indicator light will switch off when door is opened.
ñ All LED's flashing indicates power failure has occurred. Press START/CANCEL pad and reselect desired options and cycle.
-- The STATUS LED's that are lit when the door is opened will flash. Close door.
Operation
PUMP MOTOR
DRAIN MOTOR
VIO
120VAC
60HZ
ELECTRONIC
CONTROL
BOARD
*SOME MODELS
P3-4
BU
DISPENSER
R-Y
W
P3-1
W
W
R-BK
W
*VENT SYSTEMS
HEATER
W
HI-LIMIT
THERMOSTAT
R
P8
WATER VALVE
FLOAT
SWITCH
PK
P3-3
W
Y
P3-10
P3-9
P3-5
P3-7
DOOR
SWITCH
W
NEUT W
L1 BK
BK
BK
P3-6
P1
W
The water/service test is a special function
initiated from the power failure mode or idle
mode.
While in power failure mode
- simultaneously
press the HI-TEMP WASH and START/CANCEL
pads for second.
The dishwasher will then step through the test
cycle per the chart. Pushing the START/CANCEL
pad will advance the dishwasher to the next step.
While in idle mode
- simultaneously press the HI
TEMP and START/CANCEL pads for 3 seconds.
Water/Service Test
27
45
0.4
75
60
90
90
488
60 1
1
0
0
0
0
0
0
0
0
1
1
1
0
0
0
0
0
0
0
0
1
1
0
0
0
0
1
1
0
X
1
1
0
0
0
1
0
0
0
0
1
0
0
0
0
0
0
0
0
1
0
0
0
0
0
0
1
0
0
0
1
1
1
0
0
0
0
0
1
1
2
3
4
FILL/DISPENSER
STEP
TOTAL TIME (SEC)
WATER VALVE
CIRCULATION MOTOR
DRAIN MOTOR
HEATER
DISPENSER
VENT*
WASHING LED
SANITIZED LED
DRYING LED
CLEAN LED
FILL
WASH
PAUSE
WASH/HEAT
WASH/HEAT/DISP.
DRAIN
DRY
TOTAL
CLEAN LED stays on until door is opened or cycle is started.
X - denotes selectable option
5
6
7
8
0
0
0
0
0
0
1
0
1
1
1
1
1
1
Y
THERMISTOR
WARNING
Disconnect electrical power at the fuse box
or circuit breaker box before servicing under
this product. Electrical power may be
present on some parts under this product,
even if not in use.
Failure to follow this warning could result in
serious injury or death.
P3-2
This information is intended for use by
persons having electrical and
mechanical training and a level of
knowledge of these subjects generally
considered acceptable in the appliance
repair trade. The manufacturer or seller
cannot be responsible, nor assume any
liability, for injury or damage of any kind
arising from the use of this Service Data
Sheet.
