Wall Sleeve Brands:
#9 White Westinghouse or Frigidaire
22
"
Deep
1. If the wall sleeve does not have a rear grille or louvered
panel, install the plastic grille from the kit. The plastic
grille is mounted to the inside of the wall sleeve at the rear
flanges. There are (4) plastic nuts in the flanges of the wall
sleeve. If some are missing replacements are included in
the accessory kit, and can be simply pressed into the square
holes in the flanges. Place the grille against the rear flanges
and use the (4) large washers and screws to secure the grille.
11
5
7
6
6
Because of the increased unit depth, first try dry fitting
using the method described below:
2. Place (2) 1 ½” x 1 ½” x 14” seals against each side.
3. Gently slide unit in and check if amount extending from the
sleeve is sufficient once the trim frame is attached.
4. If position is okay, remove unit and Proceed to the next step.
If not go to step 8.
5. Attach (1) 1 ½” x 1 ½” x 25” long seal in the center at the
top of the sleeve. Remove the backing paper and press into
position.
6. Attach (2) 1 ½” x 1 ½” x 14” seals to the left and right sides
of the sleeve.
7. Cut the 1 ½” x 1 ½” x 25” long seal to 14” long and attach it
vertically to the rear grill 7” from the left side.
Use the next steps if the unit requires extra extension into
the room.
8. Attach 1” x ¾” 14” long seal over the solid vertical portion of
the rear grille.
9. Attach (2) 4 ½” x 3 ½” x 1 ½” foam blocks with the slot
overlapping the seal above.
10. Install the divider into the slots of the foam blocks. You may
need to trim the length to size.
11. Cut to fit the 1 ½” x 1 ½” x 25” seal to fit the top of the sleeve.
The pieces must be fitted flush to the edge of the divider.
12. Attach (2) 1 ½” x 1 ½” x 14” seals along the sides of the
sleeve again making sure all seals are flush.
13. Center unit & gently slide unit into sleeve.
14. Before sliding all-the-way back, remove 1st screw from front
on left side of unit.
15. Remove the plastic washer from the screw.
16. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
17. Slide the unit completely to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
18. Seal & Frame the unit as described on the last page of
these instructions.
11
9
8
12
←
←
7
"
→
→
