Frigidaire 40" DUAL FUEL RANGE, Руководство по установке

Страница: 3 / 20

3
40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
(Models with Electric Ovens and Gas Cooktop)
Figure 1
FOR MODELS WITH SELF-CLEAN FEATURE:
•
Remove broiler pan, food and other utensils
before self-cleaning the oven. Wipe up excess
spillage. Follow the pre-cleaning instructions in the Use
and Care Guide.
Model and Serial Number Location
The serial plate is located on the oven front frame behind
the large oven door.
Range Placement
To eliminate the risk of burns or fire by
reaching over heated surface units, cabinet storage space
located above the range should be avoided. If cabinet
storage space is to be provided, the risk can be reduced
by installing a range hood that projects horizontally a
minimum of 5" (12.7 cm) beyond the bottom of the
cabinet.
If range will be installed with a cabinet on both
sides,
draw a center line on the floor between the
cabinets (see figure 2). If back of range will not be
flush with the wall (the location of the outlet may not
allow the range to be positioned against the wall), draw
a line on the floor where the back edge of the range will
be. Now install anti-tip brackets (see "Anti-tip Brackets
Installation", page 8).
If range will be installed with a cabinet on one
side only,
move the range into final position. Draw a
line on the floor along the side of the range that is not
against the cabinet.
If back of range will not be flush
with the wall
(the location of the outlet may not allow
the range to be positioned against the wall), draw a
line on the floor where the back edge of the range will
be. Now install anti-tip brackets (see "Anti-tip Brackets
Installation", page 8).
If range will not be installed against a cabinet,
move
range into final position. Draw a line on the floor along
both sides of the range.
If back of range will not be
flush with the wall
(the location of the outlet may not
allow the range to be positioned against the wall), draw
a line on the floor where the back edge of the range will
be. Now install anti-tip brackets (see "Anti-tip Brackets
Installation", page 8).
Figure 2
Follow instructions for
the type of installation you have
Center
Line of
Range
Electrical Shock Hazard
• Electrical ground is required on this appliance.
• Do not connect to the electrical supply until
appliance is permanently grounded.
• Disconnect power to the circuit breaker or fuse
box before making the electrical connection.
• This appliance must be connected to a grounded,
metallic, permanent wiring system, or a
grounding connector should be connected to the
grounding terminal or wire lead on the appliance.
Failure to do any of the above could result in a
fire, personal injury or electrical shock.
Serial Plate Location
Factory Connected Power Supply Cord
This range is equipped with a factory-connected power
cord (see Figure 1). Cord must be connected to a
grounded 120/240 volt or 120/208 volt range outlet. If
not outlet is available, have one installed by a qualified
electrician.
When ordering
parts for or making
inquiries about your
range, always be sure
to include the model
and serial numbers
and a lot number or
letter from the serial
plate on your range.