10
SETTING SURFACE CONTROLS
NOTE
See Recommended Setting for Surface Element table on
page 7.
Figure 3
Figure 2
Figure 1
CAUTION
Radiant surface elements may appear to have cooled
after they have been turned OFF.
HE
(Hot Element)
message will turn ON and will continue to glow until
the glass cooktop has cooled down to a moderate
level.
The glass surface may still be hot
and burns
may occur if the glass surface is touched before the
indicator light has turned OFF. The message may
remain on even though the controls are turned OFF.
CAUTION
Do not place plastic items such as salt and pepper
shakers, spoon holders or plastic wrappings on
cooktop when it is in use.
These items could melt or
ignite. Potholders, towels or wooden spoons could catch
fi re if placed too close to the surface elements.
CAUTION
Do not allow aluminum foil, or ANY material that
can melt to make contact with the ceramic glass
cooktop.
If these items melt on the cooktop they will
damage the ceramic cooktop.
Dual Surface Radiant Element
The cooktop is equipped with 1 or 2 dual radiant surface
elements located at the
left front
and the
right front
position (Figure 1). Symbols around the knob are used
to indicate which coil of the dual radiant element will
heat. The symbol indicates that only the inner coil will
heat (Figure 2). The symbol indicates that both inner
and outer coils will heat (Figure 3). You may switch from
either coil setting at any time during cooking.
To Operate the Dual Surface Element
1. Place correctly sized cookware on the dual surface
element.
2. Push in and turn the control knob to the inner coil
symbol for smaller cookware (Figure 2) or to inner
and outer coil symbol for larger cookware (Figure 3).
Turn the knob to adjust the setting if needed. Start
most cooking operations on a higher setting and then
turn to a lower setting to fi nish cooking. Each surface
element provides a constant amount of heat at each
setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the
cookware is
too small
for the surface heating area.
3.
When cooking has completed, turn the surface
control knob to OFF before removing the
cookware.
Содержание 318205204
Страница 39: ...39 NOTES ...
