FRIEDRICH
Installation
fu.
WARNING
�I
Electrical Shock Hazard
Disconnect all electrical
power to unit before service
or installation. Failure to do
so can result in property
damage, personal injury
and/or death.
Mount Support Brackets to Wall Sleeve
1. Mark Top Hole location and line up bracket with
the bracket holes. See Fig 2.
Figure 2 - Side View of Metal Wall Sleeve
showing measurements for Top Hole Location.
C
1.125"
1.500"
2. Mark other 2 holes locations. See Fig. 3.
Figure 3 - Location of Attachment Holes
ATIACHMENT
HOLE LOCAT
I
O
N
S
3. Drill all 3 holes with a 1/8-in. drill bit.
Model PDXDAA & PDXDEA
4. Secure bracket (be sure to use correct bracket
as there is a left and right bracket) with 3
screws provided.
Do not over tighten.
See Fig. 4.
Figure 4 - Support Bracket Attached to Wall
Sleeve
5. Repeat procedure above for other side bracket
attachment.
Remove Discharge Grille and Control Door
from Front Panel
6. Remove front panel from unit by grasping the
panel firmly near the bottom of both sides, then
pulling the panel forward and upward to release
partition hooks. See Fig 5.
Figure 5- Removing Front Panel
PDXDAA & PDXDEA
Pg 2/5
PTAC Direct Sales, Inc.
185 S. Kimball Ave.
Suite 130
Southlake, TX 76092
877.454.7822 (T)
www.PTACdirect.com
