14
TABLE 2
MODEL
HEATER kW
Power Cord Kit
Voltage
Amperage
Receptacle
PZE / PZH07K
3.6
STD
230/208
20
NEMA 6-20r
PZE / PZH09K
3.6
STD
230/208
20
NEMA 6-20r
PZE / PZH12K
3.6
STD
230/208
20
NEMA 6-20r
PZE / PZH15K
5.0
STD
230/208
30
NEMA 6-30r
PZE / PZH09R
3.6
STD
265
20
NEMA 7-20r
PZE / PZH12R
3.6
STD
265
20
NEMA 7-20r
Electrical Wiring for 265 Volt
Models
Power Cord Installation
All 265V PTAC/PTHP units come with a factory installed non-LCDI
power cord for use in a subbase.If the unit is to be hard-wired refer to
the instructions below.
NOTE:
It is recommended that the PXSB subbase assembly,the
PXCJA conduit kit (or equivalent) be installed on all hardwire
units.If installing a flush-floor mounted unit,make sure the
chassis can be removed from the sleeve for service and
maintenance.
To install the line voltage power leads and
conduit to chassis, follow the instructions
below.
1.
Follow the removal process of the chassis’s junction box.
2.
Prepare
the
265V(or
230V)
power
cord
for
connection
to
the
chassis’
power
cord
connector
by
cutting
the
cord
to
the
appropriate
length.Power
cord
harness
selection
shown
on
Table
2
on
page14.
WARNING
Electrical Shock Hazard
Turn off electrical power before service
or installation.
ALL electrical connections and wiring
MUST
be installed by a qualified
electrician and conform to the National
Code and all local codes which have
jurisdiction.
Failure to do so can result in property
damage, personal injury and/or death.
