En-5
PREPARATION
CAUTION!
●
Take care to prevent infants from
accidentally swallowing batteries.
●
When not using the remote control unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
●
If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
●
Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
●
Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the remote control
unit’s operating range becomes appre-
ciably reduced, replace the batteries and
press the ACL button with the tip of a
ballpoint pen or other small object.
Load Batteries (R03/LR03/AAA
×
4)
1
Open the battery compartment lid.
1
Slide the battery compartment lid until it stops.
2
While strongly gripping the portion on each side of the battery com-
partment lid that has a rough surface, slide the lid until it comes com-
pletely off.
2
Insert batteries.
Be sure to align the battery polarities (
) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the TIME ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the (
)SET TIME buttons to adjust the clock to
the current time.
button:
Press to advance the time.
button:
Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the TIME ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
●
The remote control unit must be pointed at signal receiver to operate correctly.
●
Maximum operating range: Approximately 10 meters. (This may not apply when
the battery is low or there are obstacles.)
●
When a signal is properly received by the air conditioner, a beep will be heard.
●
If no beep is heard, press the remote control unit button again.
Remote Control Unit Holder
For Hand-Held use
Screws
1
Mount the Holder.
For Wall Mount use
1
Mount the Holder.
Screws
2
Set the Remote
Control Unit.
Insert
Slide up
3
To remove the
Remote Control
Unit.
Insert
2
Set the Remote
Control Unit.
3
Attach the unit to
the holder as
shown.
Screw
Slide
SET
ENERGY
SAVE
TIME
ADJUST
TEST
RUN
ACL
SET
SWING
SWING
1
2
2
2
