Friedrich M30CG, Руководство по эксплуатации

Страница: 15 / 20

En-14
TROUBLESHOOTING
OPERATING TIPS
Symptom Problem See Page
CHECK ONCE
MORE
Doesn’t operate at all:
●
Is the Power Supply Plug disconnected its outlet?
● Has there been a power failure?
●
Has a fuse blown out, or a circuit breaker been tripped?
—
● Is the timer operating? 8 - 9
Poor Cooling perform-
ance: ●
Is the Air Filter dirty?
●
Air the air conditioner’s intake grille or outlet port blocked?
●
Did you adjust the room temperature settings (thermostat) cor-
rectly?
● Is there a window or door open?
●
In the case of Cooling operation, is a window allowing bright sunlight
to enter? (Close the curtains.)
●
In the case of Cooling operation, are there heating apparatus and
computers inside the room, or are there too many people in the
room?
—
●
Is the unit set for SUPER QUIET operation?
6
The unit operates
differently from the Remote
Controller’s setting:
●
Are the Remote Controller’s batteries dead?
● Are the Remote Controller’s batteries loaded properly?
5
If the problem persists after performing these checks, or if you notice burning smells, or both the ORERATION Indicator Lamp (Fig. 3
5
) and the TIMER Indicator Lamp (Fig. 3
6
) fl ashes, or only the TIMER Indicator Lamp (Fig. 3
6
) fl ashes, immediately stop operation,
disconnect the Power Supply, and consult authorized service personnel.
AUTO Restart
In Event of Power Interruption
●
The air conditioner power has been interrupted by a power
failure. The air conditioner will then restart automatically in
its previous mode when the power is restored.
●
Operated by setting before the power failure.
●
If a power failure occurs during TIMER operation, the timer will
be reset and the unit will begin (or stop) operation at the new
time setting. In the event that this kind of timer fault occurs the
TIMER Indicator Lamp will fl ash (see Page. 4).
● Use of other electrical appliances (electric shaver, etc.) or
nearby use of a wireless radio transmitter may cause the air
conditioner to malfunction. In this event, temporarily discon-
nect the Power Supply Plug, reconnect it, and then use the
Remote Controller to resume operation.
9315345394_OM.indb 14 9315345394_OM.indb 14 9/30/2010 2:44:25 PM 9/30/2010 2:44:25 PM