8
CLEANING
Cleaning inside the Larder Fridge
You should clean the Larder Fridge internally with a weak solution of
bicarbonate of soda. Then rinse with warm water using a ‘wrung-out’
sponge or cloth. Wipe the Larder Fridge dry before replacing t he food.
Wash the baskets and shelves in warm soapy water. Ensure they are
completely dry before replacing in the Larder Fridge. Plug in and switch
on the mains supply
.
Cleaning the outside of the Larder Fridge
Use standard furniture polish to clean the Larder Fridge exterior.
Make sure that the doors are closed, to prevent polish getting on the
magnetic door seal or inside. The grille of the condenser at the back of
the Larder Fridge and the adjacent components can be vacuumed using
a soft brush attachment.
Cleaning tip
â
Defrost and clean when food stocks are low.
Moving your Larder Fridge
Location
Do not locate your Larder Fridge near a heat source, eg. cooker, boiler
or radiator. Also avoid direct sunlight.
See 'Location' on page 4.
Levelling the Larder Fridge
Make sure the Larder Fridge is level. Use the rotating levelling feet at
the front. If the Larder Fridge is not level, the doors and magnetic seal
4
.
Do not turn on the Larder Fridge for 4 hours
After the Larder Fridge is in place it needs to be left for 4 hours.
Installation
Don’t cover or block the vents or grilles of your appliance.
Servicing
Repairs and maintenance of the appliance should only be performed b
y
Changing the internal light
1
Larder Fridge and disconnect the electrical supply.
2 Push the level at the base of the light to the rear to release the light
cover.
3
Remove the old bulb by unscrewing it in an anti-clockwise direction
Replace with a new bulb (15W ) by screwing it in a clockwise direction
4
5 Replace the light cover back into position and click back into place.
6 Re-connect your Larder Fridge to the electrical supply and switch on.
making sure that it is secure in the bulb holder
MAINTENANCE
Before carrying out the bulb replacement always switch off the
