8
13
LCDI POWER CORD AND PLUG
This air conditioner is equipped with an lcDI (leakage current Detection and Interruption) power cord and plug. The
lcDI power cord and plug will shut off the supply source via electrical disconnect (circuit trip) if the nominal current
leakage between the cord shield and either load conductor exceeds a predetermined value. The cord will not be able to
conduct power until the device has been manually reset. This device provides protection to reduce the risk of fire due
to arcing faults in the power cord. The cord shields are not grounded and they must be considered as shock hazards if
exposed. The cord shield must not be connected to ground or to any exposed metal.
To ensure if the plug is working properly, please follow the following
instructions to test it:
1. Plug power cord into wall outlet.
2. Press TEST button. The circuit should trip, cutting power to the air conditioner.
3. Press RESET button for use.
DO NOT USE IF ABOVE TEST FAILS.
In the event the lcDI Plug of the power cord trips by itself, then first examine the cord for any damage. If there
is no damage to the cord, then press the ReseT button. If the lcDI Plug trips again, then immediately unplug the
power supply cord and contact a professional technician or service center.
WARNING:
Do not use the TEST and RESET buttons as “ON” and “OFF” switches.
1.
Do not press the TEST button while the air conditioner is operating.
2.
The cord and plug are designed for indoor use only.
3.
Periodically examine the cord for any damage. If the shield gets exposed,
4.
immediately unplug the power cord and do not use the unit.
TEST
POWER
RESET
TEST
RESET
POWER
INDICATOR
PLUG DIAGRAm
OPERATION Cont.
Dehumidifying mode
Turn on:
1.
Press the Power button to turn the unit on [ ].
Select Dehumidify mode:
2.
Press the Mode button [ ] until the
Dehumidify Mode indicator light is on [ ]. Or press the dehumidify
button on the remote control.
Adjust Fan speed:
3.
The fan speed will automatically set itself to Low. The
LED will display the room temperature. These settings cannot be adjusted.
Fan mode
Turn on:
1.
Press the Power button to turn the unit on [ ].
Select Fan mode:
2.
Press the Mode button [ ] until the Fan Mode
indicator light is on [ ]. Or press the Fan Mode button on the remote
control.
Adjust Fan speed:
3.
Press the Fan button [ ] to select the desired Fan
speed or select Low [ ], Medium [ ] or High [ ] on the remote
control.
Mode
Mode
