Remove the plug. (You can place
a pan beneath the plug before
removal to prevent water dripping
on the floor.)
7
14
REmOTE CONTROL
Power
Timer
Swing
˚C ˚F
Cool
Dry
Fan
Up
High
med
Low
Econ
To turn the unit on/off.
To set the timer.
To make the vertical vent swing automatically.
switch between celsius and Fahrenheit.
To select cool mode.
To select Dehumidify mode.
To select Fan mode.
To set temperature or adjust time.
To select High fan speed.
To select Medium fan speed.
To select low fan speed.
Press for the economy mode. (Only available in cool
mode.) This energy saving mode will automatically
switch the temperature to 81˚F and a low fan speed.
These settings can not be changed. To cancel, press this
button again.
Step 1
Step 2
Step 3
attach one end of the drain hose to
the drain. Keep the other end aloft
to avoid dripping.
Drain the water into the provided
water cup. Dispose of the water. Do
not drink.
WATER DRAINAGE
This product has a self-evaporative system. The condensing water will recycle to cool
the condenser. This water-cooled mode not only can improve cooling efficiency and
decrease noise, but also save energy.
In Cool and Dehumidifying Modes, water from the evaporator flows into an inside
basin. When the water reaches above a set level, the pump will run until the water is
under that level. When the basin reaches its max capacity, the compressor will stop
working, however the water pump, lower fan motor and upper fan motor will continue
running for a short time.
When the basin is full, the Water Full indicator [ ] will light and the compressor
will stop working. The buzzer will sound 10 times every 5 minutes until the water is
automatically pumped below the set level or drained by hand. If the water is neither
pumped nor drained, the unit will automatically shut off.
After draining and after a 3 minute delay, the unit will work normally.
ATTENTION: TURN OFF THE ARCTICPRO BEFORE DRAINAGE.
WARNING:
Move the unit carefully if the basin is full or water may spill into the
inside of the unit.
When the water in the basin is not enough to be pumped,
the pump will stop working. At the same time, the Water
Injection indicator on the control panel will illuminate [ ].
Make sure the drain plug is secure. Inject no more than 3
cups of water (1800ml) into the water injection port slowly.
This will also help save energy.
Down
