PFW
7
GB
Check-up
Make sure that the electrical connection is completed
and earth is connected. Put the radiator on and make
sure the fan is running.The fan speed can be
controlled in two steps with the switch on the right
hand side of the unit.
If the heater at first appears noisy, it should be
operated for at least a month before any evaluation
of sound level is done.
To change or remove the front panel
The front panel can easily be relacquered or the
appearance changed by applying a plastic film.
Disconnect the power before removing the front
panel, thereafter the two screws under the radiator
are loosened and the front panel is pulled
downwards. This must be done by a competent
electrician.
Approvals
• Protection class: IP23.
• PFW is approved for mounting with plug 230V~.
Safety
• The radiator must not be positioned immediately
below a permanent socket.
• The radiator must not be mounted outdoors.
• The radiator should be positioned out of reach of
people in showers and bathtubs.
• The radiator should be installed to ensure that
operation and maintenance can be carried out
safely.
• Before service and maintenance is started, the
power must be disconnected and the fan wheel
must have stopped.
Maintenance, service and reparation
The radiator should be cleaned when necessary,
recommended at least four a year to prevent damage
on the bearings (differs depending on the indoor
environment). If the air flow is obstructed it may
affect the operation of the radiator. Lower the
radiator forward. Vacuum the inlet grilles on the back
and underside. High pressure cleaning must not be
used to clean the radiator. Cleaning must be made
carefully and only in exeptional cases must the
radiator be opened. The radiator must only be opened
by a competent electrician. The bearings are
maintenance free and should only be changed when
necessary. Make sure no discordant sounds are
heard from the fan. Make sure that the fan wheel is
not blocked. A damaged mains cable must only be
changed by a competent electrician.