TDR-ac Installation
Page 10
Service Manual TDRac
PKII
form 9120931 rev. 11/2017
The TDR ac is placed on a stand with 2 swivel and 2 locking swivel castors.
LEGS / CASTORS
TETHERING OF THE UNIT
Warning: Safety standards require that, when this appliance is properly connected to the electrical
power supply using flexible conduit, adequate means be provided to limit movement of the ap
-
pliance without depending on or transmitting stress to the electrical conduit. This means that, as
part of the installation, the base or bottom unit of stacked models must be secured to the building
structure (typically either wall or floor) to limit the movement of the appliance and, thus, helping to
prevent damage to the conduit during cleaning, maintenance and service operations.
A tether bracket, as shown on the drawing below, is provided with the stand. Based on the routing
of the flexible conduit, the bracket must be installed along with the caster to one corner of the base
using the hardware provided. The remaining open hole in the center of the tether bracket is to
be used to secure one end of the tether (locally supplied chain, cable, etc.). The other end of the
tether is to be secured to an anchoring point in the building structure.
Note:
Length of tether must be shorter than the flexible conduit to make sure that during appliance
movement, no stress is transmitted to the conduit.
